C&K systems System 238 Manual de instalación descargar pdf (Pagina 25)

SYSTEM 238 Installation Manual

Program Option CL Program Function Comments

Audible/Visual 2E (1 & 2) Entry/Exit If Digit Postition (1) is programmed for Entry Pre-Alarm, the

Switches Pre-Alarm keypad will beep for the amount of time programmed for the Entry

Delay Time (CL 2D (3)). If Digit Position (2) is programmed for

Exit Pre-Alarm, the keypad will beep for the time programmed

into CL 2D (4), Exit Delay Time. The speed at which the keypad

beeps will increase during the last 10 seconds of the Delay time.

Alpha II keypads will display a bar graph in addition to the audible

tone.

Unit Control 2F (3) Enable 4-minute Suppresses all trouble and alarm reports for a period of four

Power-Up minutes after power is initially applied to the panel. This allows

Delay the sensors, such as PIR's time to stabilize when initializing or

prevents powered devices, such as smoke detectors, from

sending alarms when first starting panel with a dead battery or no

battery connected.

Loop Switches 30 - 37 (3) Allow Group This allows multiple loops to be shunted simultaneously with a

Shunting single keypad command. This is typically done on all interior

loops in a system.

Loop Switches 30 - 37 (4) Delay Before Dial This option programs the loops to have a delay after they are

triggered to allow the User time to shut down the system in the

event of an accidental triggering of the zone. The amount of time

is determined by the value programmed into CL 0B Digit Position

(1). The time delay may be between 10 and 150 seconds, in 10

second intervals.

1 2 ... 20 21 22 23 24 25 26 27 28

Sin comentarios

C&K systems System 238 Manual de instalación Pagina 25